Before Starting Work; Preparing The Pressure Washer For Operation; Assembling The Pressure Washer; Assembling Parts And Accessories - Stihl RE 90 Notice D'emploi

English
– Do not allow the unit to be used or stored
in freezing temperatures.
– If the pressure washer must be
transported or stored in freezing
conditions, the pump must be filled with
antifreeze to prevent cracking due to
water expansion, @ 12.2.
SAVE THESE
INSTRUCTIONS!

7 Before Starting Work

7.1

Preparing the Pressure Washer for Operation

Before starting work:
► Clean the water filter, if necessary, @ 15.4.
► Place the pressure washer on flat and firm ground or other
solid surface in an open area.
► Connect the high-pressure hose, @ 8.2.1.
► Connect the spray gun and lance, @ 8.3.1.
► Insert the spray nozzle, @ 8.4.1.
► If desired, add detergent, @ 11.2.
► Connect the water supply, @ 9.
► Connect the power supply cord to a properly installed
electrical outlet that matches the voltage and electrical
frequency stated on the pressure washer's rating plate.
16

8 Assembling the Pressure Washer

8.1

Assembling Parts and Accessories

WARNING
To reduce the risk of severe injury from high-pressure spray,
always switch off the pressure washer, shut off the water
supply, relieve any remaining pressure in the system and
lock the spray gun trigger before attempting to assemble the
pressure washer or spray attachment.
Bracket for High-Pressure Hose
3
1
► Place the bracket (1) in the guides (2) until it audibly
engages.
► Attach the bracket with the two plugs (3).
7 Before Starting Work
2
3
0458-002-8221-A