Publicité
Problem
Possible Cause
Saw blade gets loose
1. Fastening nut tightened insufficiently
after turning off the
motor
Burns on the cutting
1.
surface
2.
Engine won't start.
1.
2.
3.
4.
5.
6.
7.
Engine runs irregularly.
1.
2.
3.
4.
5.
6.
7.
Overheated engine
1.
2.
3.
4.
Troubleshooting
bodkin saw blade
Wrong saw blade
Spark plug wire disconnected.
No fuel or old fuel.
Choke not in the open position.
Clogged fuel line.
Fouled spark plug.
Flooded engine.
Low engine oil level
Loose spark plug wire.
Engine running with CHOKE.
Clogged fuel line or stale fuel.
Blocked ventilation.
Water or dirt in fuel system.
Dirty air filter.
Incorrect carburettor adjustment.
Low engine oil level.
Dirty air filter.
Air flow restricted.
Carburettor not adjusted properly.
Help
1. Tighten fastening nut, right-handed thread
1.
Insert a sharpened saw blade
2.
Change the saw blade
1.
Connect the spark plug wire to the spark
plug securely.
2.
Fill with clean, fresh gasoline.
3.
The throttle lever must be positioned at
cold start at choke position.
4.
Clean the fuel line.
5.
Clean, replace or adjust spacing.
6.
Wait a few minutes before trying again,
but do not let the engine suck in.
7.
The oil guard keeps the oil level low pre-
venting the engine from starting - Check
the oil level.
1.
Connect and tighten spark plug wire.
2.
Move the choke lever to OFF.
3.
Clean the fuel line. Fill the tank with
clean, fresh gasoline.
4.
Clean the ventilation.
5.
Empty the tank. Fill the tank with fresh
fuel.
6.
Clean or replace the air filter.
7.
Consult the service
1.
Fill crankcase with proper oil.
2.
Clean the air filter.
3.
Remove and clean the case.
4.
Consult the service
35
Publicité
