Publicité
Starting the engine, Fig. 7
Follow the procedures below for a cold start:
1.
Open the fuel valve (B) to the right in the opening
position.
2.
Turn the choke lever (A) on the engine to fully acti-
vated position to the left.
3.
Move the throttle lever (C) on a semi-open position.
4.
Turn the ignition switch (E) to ON.
5.
Pull slowly several times the reverse starter hand-
le (D) so that the fuel flows into the carburettor.
Then hold the reverse starter handle (D) and pull
the cable out slightly until you feel resistance. Then
pull the cable in a quick motion and let the cable
rewind slowly again. Do not allow the cable to snap
back. Tighten if necessary, the reverse starter handle
(D) repeatedly until the engine starts.
6.
Let the engine warm up for a few seconds. Then
gradually move the choke lever (A) to the right in
the „OPEN" position.
The restart of an engine that is already hot from the pre-
vious operation usually does not require use of the choke.
1.
Open the fuel valve (B) to the right in the opening
position.
2.
Move the throttle lever (C) on a semi-open position.
3.
Turn the ignition switch (E) to ON.
4.
Then hold the reverse starter handle (D) and pull the
cable out slightly until you feel resistance. Then pull
the reverse starter handle (D) in one swift movement
and leave the cable to wrap back slowly. Do not
allow the reverse starter handle (D) to snap back.
After the engine starts, move the throttle lever (C) to
full throttle position, so that the splitter can achieve its
maximum working force.
Sawing
1. Turn on the machine.
2. Wait until the saw blade has reached full speed.
3. Put the wood on the rocker.
4. Take hold of both handle bars of the rocker with both
hands and lead it evenly to the saw blade; thus the
saw blade is revealed.
5. Push the rocker evenly to ensure the engine speed
does not drop.
6. Remove the sawn wood from the rocker before putting
on the next piece.
25
Publicité
