Commissioning
Before commissioning observe the safety notes.
•
All safety and auxiliary installations must be fitted.
•
Check the rocker inlet for wear and replace it if nec-
essary.
•
Check the rocker that it returns to its home position
autonomously.
•
Check the saw blade for perfect fitting and correct
direction of rotation.
•
Changeover, setting, measuring and cleaning op-
erations are only to be conducted with the motor
switched off. Unplug the spark plug and wait for the
stop of the rotating tool.
•
The saw is constructed solely for the cross cutting
of firewood.
•
Regardless of the diameter of the wood only one work
piece is to be put on the rocker.
•
ATTENTION! Do not saw faggots or multiple pieces
at once.
•
Put curved wood on the rocker in such a way that the
curved-out side is directed to the saw blade (Fig. 6).
•
Ensure the machine is securely placed on solid
ground.
•
Prior to each startup of the device, the two shaft be-
arings must be lubricated on the lubricating nipples
using bearing grease (fig. 13; A).
Engine oil
m Oil has been drained for shipping. Failure to fill engine
sump with oil before starting engine will result in
permanent damage and will void engine warranty.
Fill with engine oil according to the maintenance sche-
dule.
Operation notes
Make sure the machine is completely and expertly as-
sembled. Check before every use:
•
The machine for any possible damage.
•
The firm seat of all bolts.
•
The motor oil level and the fuel level.
Refuelling
Fill only with clean fuel with a minimum of 90 octane
and a maximum of 5% of bio-ethanol in the fuel tank.
With the help of the fuel gauge you can check the level
of fuel in the tank comfortably even during operation.
m The tank must be filled to a maximum of 12.5 mm (1/2")
below the lower edge of the filler neck to have room for
expansion.
23