Monacor TVCCD-600COL Mode D'emploi page 13

Due to the installed automatic electronic shutter of
this camera also lenses with a manual iris adjust-
ment can be used.
Attention! The lenses of the lens assembly and the
CCD image sensor chip must be protected against
dust or other impurities and must not be touched with
the fingers in any case.
5 Mounting of the Camera
The camera can be mounted with a camera mount-
ing support (e. g. MONACOR TVH series) at the wall
or ceiling. For this a
vided at the top and bottom side. For outside mount-
ing the camera must be placed into a weatherproof
housing (e. g. MONACOR TVG-300).
6 Connection of the Camera
1) Connect the output jack VIDEO OUT (10) via a
75 Ω cable (e. g. MONACOR VEC-62/10) with one
or several monitors. Watch the correct 75 Ω termi-
nation at the monitor resp. with series connection
at the last monitor. With a cable length of more
than 100 m a video amplifier should be switched
between the camera and the monitor to compen-
sate for cable losses.
When using several cameras, insert a video
splitter (e. g. MONACOR TVSP-410) or a camera
switcher (e. g. MONACOR TVS-410/-810) be-
tween the cameras and the monitor.
2) When using a lens with video signal controlled iris
(auto iris) connect the cable of the lens to the
included plug (see chapter 4 "Lens") and insert
the plug into the AUTO IRIS jack (1).
3) For the power supply connect an electronically
regulated 12 V
1
/ " mounting thread each is pro-
4
power supply, e. g. MONACOR
GB
13