Mounting The Camera - Monacor TVCCD-450 Mode D'emploi

the C mount adapter ring (5). When using
a CS mount lens, remove the adapter ring
(5) and screw the lens directly onto the
thread ring (2).
3) When using a lens with automatic iris con-
trol (AI lens or DC lens), it must be con-
nected via the supplied 4-pole plug to the
jack LENS (3). Solder the connection cable
of the lens to the plug according to the pin
configuration of the jack LENS (see fig. 3).
AI lens
Pin 1 operating voltage 9 V
Pin 2 must not be connected
Pin 3 video signal 1 Vpp
Pin 4 ground
4) Connect the plug of the lens connection

6 Mounting the Camera

The camera may be mounted on a camera
stand, on a tilt/pan head (e. g. MONACOR
VPT-50) or onto a camera support (e. g. a sup-
port of the MONACOR TVH series). For fixing,
the camera is provided at the bottom side with
an adapter (7) with a thread jack (thread
DC lens
6.3 mm/
damp coil -
screwed to the camera top side for hanging
mounting.
damp coil +
drive coil +
must be placed into a weatherproof housing
drive coil -
(e. g. MONACOR TVG-300).
cable to the jack LENS.
1
/ "
). The adapter can alternatively be
4
In case of outside mounting the camera
GB
15