Applications; Mounting And Setting-Up; Connection Of The Units; Monitor Or Video Recorder - Monacor TVSET-400 Mode D'emploi

3 Applications

GB
The video surveillance system TVSET-400 is suitable
for indoor and outdoor monitoring. It consists of a
switch-over unit with infrared remote control, a B/W
camera of type TVCCD-520 with integrated micro-
phone in a splashproof housing, and a power supply
unit. The system can be extended to maximal four
cameras of the same type.
The switch-over unit has an audio and video output
for surveillance of picture and sound on a monitor or
TV set with AV input or for recording with a video recor-
der. An AV connection cable with phono plugs is sup-
plied together with the set.

4 Mounting and Setting-up

Place the switch-over unit so that the remote control
can directly be pointed towards the infrared receiver
which is located behind the cover next to the channel
display (1). To avoid heat accumulation, the place of
setting up the switch-over unit must be chosen so that
sufficient air circulation is ensured during operation.
If necessary, the camera must first be connected to
the supplied cable. For this purpose connect the four-
pole push-on plug (c) to the jack according to fig. 5,
insert the strain relief (d) into the guide rail (b), finally
place the cover plate (a) and screw it tightly.
b
The camera is connected via a ball joint to a bracket
for wall mounting. Fix the camera by means of the sup-
plied screws to a wall. Align the camera at the ball joint
to the desired surveillance area. The panning range is
±70°, the tilting range +30°/-25° (in relation to the hori-
zontal level).
Prior to mounting the wall bracket definitively, check
if the camera can be adjusted to the desired surveil-
lance range from the position provided.
8
a
c d
Camera connection cable
5 Connection of Units

5.1 Monitor or video recorder

Connect the supplied cable with the 9-pole mini DIN
plug to the OUTPUT jack (2). Connect the inputs of a
monitor or the AV input of a TV set to the phono plugs
of the cable. In this case the video signal is present at
the yellow plug and the audio signal at white plug.
However, for video and audio recordings connect
the phono plugs to the audio and video inputs of a
video recorder.

5.2 Connection of the cameras

Connect the camera(s) via the respective cable with
the mini DIN plugs to the jacks CH1 to CH4 (3).

5.3 Power supply

Connect the direct voltage plug of the supplied plug-in
power supply unit to the jack DC IN 12V (4). Then
connect the power supply unit to a mains socket
(230 V~/50 Hz). The power supply of the camera(s) is
made via the switch-over unit.

5.4 Power supply of the infrared remote control

The infrared remote control for the switch-over unit is
supplied via a 3 V lithium button cell of type CR2025.
The battery compartment is on the lower side of the
remote control. To insert or change the battery, slide
the latch of the battery compartment drawer to the
right (1st arrow in fig. 6), and, while sliding, pull out the
drawer downwards at the recessed handle (2nd
arrow). Insert the battery with the negative and posi-
tive poles as imprinted on the drawer.
1. 2.
Do not put exhausted batteries into the household
rubbish but take them to the special waste disposal
(e. g. collective container at your electrical supply
shop).
CR2025
3V
CR2025
Battery replacement