Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
REPAIR AND ORDERING OF SPARE
PARTS
Exchanging the power cable
If the power cable of this electric power tool is
damaged, it must be replaced by the manufac-
turer, its customer services department or a
similarly qualified person to avoid danger.
Spare parts/Accessories
Spare parts can be ordered through the Cus-
tomer Service using the following information:
•
Type of device
•
Model of the unit
•
ID number of the device
TROUBLESHOOTING
Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
Blade will not cut a straight
line.
30
7062413-digital-display-MA-#-1604-19.indb 30
Transport
•
Do not lift the tool by the mains cable
•
Transport the tool in its original packaging
to avoid transport damage
•
Remove all accessories before transport-
ing the tool
Storage
Store the tool and its accessories in a dark, dry
and frost free environment, inaccessible to
children. The perfect storage temperature is
between 5 and 30°C. Always keep the tool in
the original packaging. Clean the tool before
storage.
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn
down.
Sawdust accumulated,
blocking the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Possible Solution
Check to make sure power
cord is connected well into a
working outlet.
Unplug the power cord.
Replace it by a qualified
maintenance person.
Replace the carbon brush by
a qualified maintenance
person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and
reassembled it as described
in install /change the Blade
section.
Mount a new, sharp blade on
the saw.
Check that blade is properly
mounted.
Use and edge guide.
11-05-16 11:37
Publicité
Table des Matières
