Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
tool and inspect the workpiece. Move
forward at a slower speed.
Line cuts
You can follow a drawn line with the help of the
indicator marks (a), at the front and rear of the
safety guard. For precise work, the relationship
between the saw cut and a marked indicator
line must be established using a test piece.
The ideal positioning of the saw cuts must then
be achieved by adjusting the indicator line to
the target line.
Working with large workpieces
When working with large workpieces or cutting
straight edges:
•
Use fastening clamps to tighten a board or
border onto the workpiece as an auxiliary
stop.
•
Guide the left-hand side of the base plate
along the auxiliary stop.
Plunge cuts (Figure 1)
Note: Some very hard materials are not suita-
ble for plunge cuts.
1.
Put the base plate on the workpiece.
Make sure that the rear lateral depth mark-
ing is at the height of the beginning of the
cut.
2.
Switch on the electric power tool and
allow a couple of seconds to pass until the
tool insert reaches its full speed. Then
plunge the tool insert, slowly but with
some pressure.
3.
Push the electric power tool forwards
through the workpiece.
4.
When you reach the end of the cut, switch
off the electric power tool and pull it out of
the workpiece.
Cutting tiles
Adhesive tape or insulation tape on the work-
piece makes the work easier and helps to
prevent it from getting scratched.
After use:
1.
Switch of the tool
2.
Remove the plug from the socket
3.
Let the tool cool down
4.
Remove all accessories such as
sawblades
7062244_MaxxSaw_Ma_#1503-19.indb 29
CLEANING AND MAINTENANCE
Warning! Pull out the power plug
before any cleaning work.
Cleaning
•
Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
tool with a clean cloth or blow over it with
low pressure compressed air.
•
We recommend that you clean your elec-
tric power tool immediately after each use.
•
Clean the electric power tool regularly with
a damp cloth and somewhat soft soap. Do
not use any cleaning or solvent materials;
these can attack the device's plastic com-
ponents. Make sure that no water can get
inside the electric power tool.
•
Unlock and remove the lid if the adapter is
dusty. Replace the lid after cleaning.
Maintenance
Carbon brushes
In the event of excessive sparking, allow a
qualified person to examine the carbon
brushes.
ATTENTION! The carbon brushes
may only be exchanged by a qualified
person.
There are no inner parts of the tool which need
maintenance.
REPAIR AND ORDERING OF SPARE
PARTS
Exchanging the power cable
If the power cable of this electric power tool is
damaged, it must be replaced by the manufac-
turer, its customer services department or a
similarly qualified person to avoid danger.
Spare parts/Accessories
Spare parts can be ordered through the Cus-
tomer Service using the following information:
•
Type of device
•
Model of the unit
•
ID number of the device
Transport
•
Do not lift the tool by the mains cable
•
Transport the tool in its original packaging
to avoid transport damage
.
English
29
27-08-15 09:42
Publicité
Table des Matières
