MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3.
Connect the power supply cable (21) to the electrical mains.
WARNING!
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
4.
Lower the squeegee (11) with the lever (19).
5.
Turn the solution fl ow control lever (4) to one of the following positions, according to the type of cleaning to be performed:
•
Smart solutions: rotating the lever (4) to the ECO position (5) causes the machine to work in a special condition of set
water usage; having a preset and constant water fl ow, the machine can work with an autonomy of 70-80 minutes (0.3 liters/
min on average).
•
Variable system: when the lever is turned to the left (variable fl ow) the fl ow rate can increase up to 1 liters/min.
•
In no case it is possible to close completely the water fl ow to the brushes during operation.
6.
While keeping the hand on the handlebar (2), start the machine by turning the brush/pad-holder switch and the vacuum system
switch (52 and 53) to "I".
Stopping the machine
7.
Turn the brush/pad-holder switch and the vacuum system switch (52 and 53) to "0".
8.
Disconnect the power supply cable (21) from the electrical mains.
9.
Lift the squeegee with the lever (19).
10.
Insert the positioning pin (24) and lift the brush/pad-holder by activating the transport/parking device (23a).
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the fl oor.
CAUTION!
To avoid damaging the fl oor surface, do not use the brushes without the solution and, when the machine is not
operating, stop the brush/pad-holder by pressing the switch (52).
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (52).
3.
If necessary, adjust the solution quantity by using the lever (4).
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in fi gure 3.
Machine speed adjustment
4.
The machine speed varies according to the type of fl oor to be cleaned and the choice of using the brush or the pad.
If necessary, it is possible to adjust the machine speed by following the relevant procedure in the Maintenance chapter.
A
Micromatic™ M17E
INSTRUCTIONS FOR USE
Figure 3
909 5855 000(4)2009-11
ENGLISH
B
13
P100160