IKRA BT 4344 Mode D'emploi page 19

Petrol brushcutter
INTRODUCTION
Thank you for your purchasing a brush cutter provided by our company. These Operating Instructions explains
the correct handling and operation of your brush cutter. Read these Operating Instructions carefully before
operating the device, operate the device correctly and always pay attention to operate the device in a safe way.
Please note that due to technical changes some of the actual specifications of your device may differ from those
given in these Operating Instructions.
RATINGS
MODEL
Main unit Power transmission
Maximum speed of gear shaft /
engine speed (r/min)
Idle speed (r/min)
Vibration level at handle (m/s²)
Sound pressure value [dB(A)]
Reduction ratio
Direction of rotation of blade
Type of handle
Engine Designation
Type
Displacement (ml)
Max. output (kW at r/min)
Carburettor type
Ignition
Starter type
Fuel type
Fuel tank capacity (l)
Fuel consumption (g/kWh)
Dry weight (kg)
Length of main tube (mm)
Length of drive shaft (mm)
Standard blades (mm)
Technical data are subject to change without notice.
Specifications, descriptions and illustrative material in these Operating Instructions correspond to current knowl-
edge at the time of publication and are subject to change without notice. Illustrations may display optional equip-
ment and accessories, and may not include all standard equipment.
Please do also consider any local regulations
concerning noise protection!
Noise emission information in accordance with the
German Product Safety Act (ProdSG) and the EC
Machine Directive: the noise pressure level at the
place of work can exceed 80 dB(A). In such cases the
operator will require noise protection (e.g. wearing of
ear protectors).
SAFETY RULES & PRECAUTIONS
The safety rules and precautions applicable in each
case must be observed. As all power-driven devices,
also this device must be handled and operated using
appropriate care. DO NOT EXPOSE YOURSELF OR
OTHERS TO DANGER. Follow the general rules giv-
BT 4344
automatic centrifugal clutch; spiral bevel gear; drive shaft
7800/9500
2800 min ± 150
-1
2
max 8,0 [K 1,5 m/s ] EN ISO 11806
94 dB (A) [K 3,0 dB(A)] EN ISO 11806
17 : 22
counter-clockwise (seen from the top)
double handle
1E40-2E
air-cooled, 2-cycle, vertical piston valve,
spark ignition engine
42,7
1,1 / 7500
diaphragm-type
contactless electronic ignition
recoil starter
2-stroke mixture (30:1)
1000 ml
< 610
8.7
1500
1522
CG420-2 255mm 3-tooth (255x1.4)
en in these Operating Instructions. Do not allow other
persons to use this device unless they act in a respon-
sible manner and have read and understood the Op-
erating Instructions and are familiar with its operation.
• Always wear safety goggles for eye protection.
Dress properly, do not wear loose clothing or jewel-
lery that may get caught in moving parts of the unit.
Always wear safe, sturdy, antiskid footwear. Long
hair should be tied back. It is recommended that
the legs and feet are covered during operation to
protect them from thrown objects.
• Inspect the entire device for loose parts (nuts, bolts,
screws, etc.) and any damage. Repair or replace
the device/parts as necessary before using the de-
vice.
GB-2