Installation; General - Hatco Flav-R-Savor LFST-48 Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Hatco Flav-R-Savor Large Capacity Holding and Display
®
Cabinets are shipped with most components pre-assembled.
Care should be taken when unpacking shipping carton to avoid
damage to the unit and components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAZARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
Transport unit in upright position only. Before moving or
tipping unit, secure all glass surfaces, doors, pan rails,
and/or skirts with tape. Failure to do so may result in
damage and injury.
The National Sanitation Foundation (NSF) requires that
units over 36" (914 mm) in width or weighing more than
80 lbs. (36 kg) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, accessory 4" (102 mm) legs are available to allow for
proper cleaning access below unit.
1. Remove the unit from the carton. Two people are required
for this step.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the IMPORTANT
OWNER INFORMATION section for details.
2. Remove tape and protective packaging from all surfaces
of unit.
3. Install the shelf rack and shelves inside the cabinet.
a. When placing shelf rack inside the cabinet, rods on
bottom of rack must be inside floor pins.
b. When installing wire shelves, set directly on top of rack
shelf pins. Insert shelves with reinforcement to the front.
Floor Pin Floor Pin
Installing the Shelf Rack
CAUTION
Locate side rods
outside floor pins.
Locate bottom rods
inside floor pins.
4. Install the door handles using the
supplied handle screws.
5. Install signage into the sign
holders. Refer to the "Sign
Dimensions" in this section for
more information.
6. Place the unit in the desired
location.
• Locate the unit in an area
where the ambient
temperature is constant and
a minimum of 70°F (21°C). Avoid areas that may be
subject to active air movements or currents (i.e., exterior
doors, near exhaust fans/hoods, and air conditioning
ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet/legs on the bottom of the unit are
positioned securely on the countertop.
Installing the Signs into the Sign Holders
Sign Dimensions
Control Side: 3-1/2" (89 mm) high x 31-15/16" (811 mm) wide
Customer Side: 3-1/2" (89 mm) high x 45" (1143 mm) wide
Ends: 3-1/2" (89 mm) high x 22-5/8" (575 mm) wide
6
English
Door
Handle
Handle
Screw
air
Form No. LFSTM-1019