Installation; General; Assembly - Hatco Glo-Ray GRCMW-1 Série Manuel D'installation Et D'utilisation

INSTALLATION

General

The Glo-Ray merchandiser Warmer is shipped with most
®
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to unit and
components enclosed.
WARNING
ELECTRIC ShOCK hAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE hAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support weight of unit and contents.
NOTE: Unit must be transported in the upright position.
1. Remove the unit from the carton.
2. Remove tape and protective packaging from all surfaces of
unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
NOTICE
Do not lay unit on the side with the control panel. Damage
to the unit could occur.
Do not drag or slide unit when moving or installing.
Carefully lift unit to prevent the rubber feet from tearing off.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70° F
(21° C). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure all the feet on the bottom of the unit are
positioned securely on the countertop.

Assembly

Position the unit upright on the counter near the location it will
be used. Installation of the following items is required before
operating the unit:
Qty. Item
1 Back mirror Glass Panel, P/N 04.40.291.00
2 Glass Side Panel, P/N 04.40.289.00
(Polycarbonate side panels are available as an
option [P/N 04.12.348.00])
1 Polycarbonate Sneeze Guard, P/N 04.12.326.00
Installing the Mirror Glass Panel
Use the following procedure to install the back mirror glass panel.
1. Position the mirror glass panel with the mirror side of the
glass facing the inside of the unit.
2. Carefully guide the mirror glass panel into the rear brackets
located on the back of the unit, and lower the panel until it
reaches the bottom bracket.
Mirror
Side
Installing the Back mirror Glass Panel
Installing the Side Panels
Use the following procedure to install the glass side panels or
the optional polycarbonate side panels.
1. Remove the thumbscrews, washers, spacers, and top
bracket from the top frame.
2. Position the side panel so that the curved edge is facing
the front of the unit.
3. Carefully lower the bottom edge of the side panel into the
bottom bracket.
Do not allow the side panel to drop into position. Chipping
or breakage could occur. Carefully set the side panel into
the bottom bracket.
4. Place the top bracket over the two screw pegs on the top
frame. The top bracket will fit over and secure the top edge
of the side panel.
5. Thread the two spacers onto the screw pegs. Tighten
securely, but do not over-tighten.
NOTE: Save the thumbscrews and washers for use during
installation of the sneeze guard.
6
English
Mirror Glass
Panel
Rear Bracket
Bottom Bracket
CAUTION
Form No. GRCmWm-1216