Unit Parts Identification - Carrier 42QHG009D8SSET Manuel D'installation

UNIT PARTS IDENTIFICATION

1. Power cord conductors are distinguished according to color as follows (see Fig.a)
2. For your safety and protection, this unit is earthed through the power cord (see Fig.b) Please
contact the manufacturer or its service agent or a similar qualified person if you want to
replace it.
3. Be sure that the unit being correctly grounded. The wall outlet (Air-break switch) should be
provided with reliable earth wire.
4. The unit should be provided with an individual circuit and the circuit breaker/fuse rating
should be the same as that of the power cord and wall outlet.
POWER
CORD
E-Earth wire, yellow/green
N-Neutral wire, blue
A-Active wire, brown
Accessories
Sean (※) Drain Joint (※)
(Used on
drain joint)
1 1
NOTE: Optional parts(※), depending on model you purchased.
NOTE: All the illustrations in the manual are for explanation purpose only. Your air conditionar
may be slightly different. The actual shape shall prevail.
A
E
N
Fig.a
Drain Tray (※) Wooden screw
(optional)(※)
or
1pec 1pec
1. Front panel
2. Air filter
3. Frame
4. Cabinet
5. Air inlet grille (outdoor side)
6. Air outlet grille
7. Electronic control keypad
8. Power supply cord
Wall outlet Air-break switch
Rubber Plug
1 or 2
8
(depend on model you
purchased)
Fig.b
Screw
2 (For ≥18000Btu/h models
only: Used to fasten the
front panel)
2 or 4 (Used to install the
drain tray)
08