Carrier 42QHG009D8SSET Manuel D'installation page 11

OPERATING INSTRUCTIONS (continued)
POWER:
Press the POWER keypad to turn the unit on/off.
MODE:
Press the "MODE" keypad to select the appropriate operating mode. For the Cooling & Heating
models, the mode selection will alternate between AUTO, HEAT, COOL, FAN and DRY. For the
Cooling only models, select the operating mode from AUTO, COOL, FAN and DRY. The green
indicator light beside the "MODE" option will illuminate, identifying the mode selected.
When using the DRY and AUTO mode, you cannot select a fan speed. The fan motor operates
on LOW speed in DRY mode and on MED speed in AUTO mode.
▲TEMPERATURE SETTINGS UP:
Press the ▲ keypad to increase the set (operating) temperature of the unit.
Each time the keypad is pressed the temperature increases as follows:
1 °C (Celsius Scale) Maximum Setting 30 °C
▼TEMPERATURE SETTINGS DOWN:
Press the ▼ keypad to decrease the set (operating) temperature of the unit.
Each time the keypad is pressed the temperature decreases as follows:
1 °C (Celsius Scale) Minimum Setting 17 °C
NOTE: The temperature display on the main unit can be changed between "Celsius" or
"Fahrenheit" by remote controller.
FAN:
Press this keypad to activate the appropriate fan speed setting. Each depression of the keypad
will alternate through LOW, MED, HIGH fan speed options.
The green indicator light beside the FAN speed option will illuminate, identifying the fan speed
selected.
SWING: (on some models)
Press the "SWING" keypad to activate the automatic air swing (oscillation) feature. The green
indicator light adjacent to the "SWING" keypad will illuminate, identifying to the selected mode
is operational. The vertical louvers will oscillate back and forth (side to side) automatically
sweeping air alternately for comfortable cooling/heating. To stop the air swing feature, press the
"SWING" keypad again, the green indicator light adjacent to the keypad will go off.
Press the "SWING" keypad for 2 seconds will activate the SLEEP mode which can reduce noise
creating a comfortable sleeping environment.
When the SLEEP mode is activated, the green indicator light beside the "SLEEP" function will
illuminate.
TIMER:
● First press the Timer button, the indicator light besides word On illuminates. It indicates the
Auto Start program is initiated.
● Press or hold the Up(▲) or Down(▼) to change the Auto time by 0.5 hour increments, up
to 10 hours,then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start.
10