Pairing Device; Pair With Sz909 Chest Belt (Or Other Ant-System Chest Belts); Pair With Ant-System Foot Pod / Bike Pod - Oregon Scientific SE833 Mode D'emploi

and humid (about 90%) environment.
- Do not place or wash the chest belt under running
water, instead clean it with a wet cloth.
- Do not place the conductive rubber face down on a
metal table or surface.
- Properly dry the chest belt immediately after use.

PAIRING DEVICE

IMPORTANT
To ensure accurate calculations with your
exercise, you should pair the watch with SZ909 chest belt.
This chest belt allows pairing of both heart rate and foot pod
functions.
The watch can also pair with other chest belts and devices
such as foot pod and bike pod that use the ANT Sports
System. However, other chest belts can only allow pairing
of heart rate function.
1. Press MODE repeatedly to select
will show how many and which devices are paired
(if any). If no device is paired, the watch will show "0
DEVICE PAIRED".
2. Press SET to enter "PAIR DEVICE". Press SET to start
pairing.
PAIR WITH SZ909 CHEST BELT (OR OTHER
ANT-SYSTEM CHEST BELTS)
You have 2 ways to pair the watch with chest belt.
One way is to strap the belt across your chest, and wait
•
until the watch displays
The other way is as follows:
•
i. Hold the chest belt firmly with your thumbs touching
ii. Rub your thumbs back and forth across the
. The watch
NOTE
Only with SZ909 chest belt can you pair both HR belt
and foot pod. If you pair with other ANT-system chest belt,
only HR belt can be found.
NOTE
successful when both HR belt and foot pod are found.

PAIR WITH ANT-SYSTEM FOOT POD / BIKE POD

You can purchase foot pod or bike pod separately to pair
with your watch, as long as they use the ANT system. For
9
and
(only with SZ909)
the conductive pads that normally contact your
chest.
conductive pads a few times until the watch displays
the screens above.
For SZ909 chest belt, pairing is only considered