Publicité
New IEEE-Bus Commands
The new firmware was extended by the following IEEE-bus commands:
• Query for currently used limits in operating modes GSM BTS ANALYZER (FSE-K11) and GSM MS
ANALYZER (FSE-K10), Phase Frequency Error measurement.
• Query for currently used limits in FSE-K20/K21 Modulation Accuracy measurement.
• Trace averaging method selectable.
New or extended commands for option FSE-B7 and firmware applications FSE-K10, FSE-K11, FSE-
K20, FSE-K21, FSE-K30 and FSE-K31 are included in the updated FSE operating manual and therefore
not described in this supplement.
The commands are listed in alphabetical order. In the individual description, the complete notation of the
command is given. An example for each command, the *RST value and the SCPI information is written
out at the end of the individual description. The modes for which a command can be used are indicated
by the following abbreviations:
A
Spectrum analysis
A-F
Spectrum analysis - frequency domain only
A-Z
Spectrum analysis - time domain only (zero span)
VA
Vector signal analysis (option FSE-B7)
VA-D
Vector signal analysis - digital demodulation (option FSE-B7)
VA-A
Vector signal analysis - analog demodulation (option FSE-B7)
BTS
GSM BTS analysis (options FSE-K11, FSE-K21, FSE-K31)
MS
GSM MS analysis (options FSE-K10, FSE-K20, FSE-K30)
Note:
The spectrum analysis (analyzer) mode is implemented in the basic unit. For the other modes,
the corresponding options are required.
Modification of Commands for GSM/EDGE Applications:
:CONFigure[:BTS]:LIMit:PPEak <numeric_value>
This command determines the phase error limits in degrees for the phase/frequency measurement
(peak value).
Example:
Features:
Mode:
For firmware 3.20/4.20 and higher, the query :CONFigure[:BTS]:LIMit:PPEak? reads out the error
limits currently used in the measurement. I.e., if the standard limits are used, these limits are read out,
and if the user limits are used, the set user limits are read out. For firmware versions < 3.20/4.20,
always the user limits were read out even if the standards limits were used.
This modification also applies to the following commands:
:CONFigure[:BTS]:LIMit:PRMS
:CONFigure[:BTS]:LIMit:EVMRms
:CONFigure[:BTS]:LIMit:EVMPeak
:CONFigure[:BTS]:LIMit:OSUPpress
:CONFigure[:BTS]:LIMit:PERCentile
:CONFigure[:BTS]:LIMit:FREQuency
:CONFigure[:MS]:LIMit:PPEak
:CONFigure[:MS]:LIMit:PRMS
:CONFigure[:MS]:LIMit:EVMRms
:CONFigure[:MS]:LIMit:EVMPeak
:CONFigure[:MS]:LIMit:OSUPpress
:CONFigure[:MS]:LIMit:PERCentile
:CONFigure[:MS]:LIMit:FREQuency
1065.6000.30
":CONF:LIM:PPE 66"
*RST value:
depends on selected standard
SCPI:
device specific
BTS
I
E-23
Publicité
Chapitres
