Maintenance And Care; Cleaning Prgram - Rotel Adagio 277 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Maintenance and care

5.1 Filter
Through a dealer you can obtain a special filter for the water tank as a special acces-
sory. If this filter is correctly used, the decalcifying intervals for your machine will be
lengthened.
After fitting the filter, please set the water hardness to step 1 (see item 4.1). The
decalcifying indication will then only appear after a water consumption of
ca. 120 l.
Insertion/change filter
• Drain the water tank (16) and screw the filter into the mounting supplied (21) using the
enclosed mounting aid (20).
• At the date ring (months) at the top end of the filter cartridge, set the installation and
replacement date.
• Fill the tank with fresh water and reinsert the tank in the machine.
• The new filter must be rinsed before first use: hold a container under the steam/hot
water nozzle (8) and turn the rotary knob (7) clockwise. The system is then rinsed.
• Reclose the rotary knob (7) after drawing off ca. 2 – 2.5 dl of water.
The effectiveness of the filter is exhausted after about 50 l of water or after
2 months at the latest.
Without a filter
If you should no longer wish to use the filter, please do not forget to set the appropri-
ate water hardness.
5.2 Cleaning program
If the coffee machine needs to be cleaned, the
The central unit must be cleaned before starting the cleaning program (see
under item 5.4 «Cleaning the central unit»).
You can continue to brew coffee or draw hot water and steam. However, we
recommend that you run the cleaning program as soon as possible.
Caution:
– You may not interrupt the cleaning program.
– Throughout the process the symbol is blinking.
– Please follow the stated sequence exactly.
• Switch off the machine with the On/Off button (3) (Stand-by mode).
• Press the On/Off button (3) and the 1-cup button (4) simultaneously for ca. 4 seconds.
• The symbol
• Remove and clean the drip pan (10b) and the grounds container (10c) and then
replace them both. The symbol
• Open the cover of the powder shaft (17). The symbol
• Place the cleaning tablet in the powder chute and close the cover.
lights and the symbol
symbol appears.
blinks.
now also lights.
blinks.
29

Publicité

Table des Matières
loading

Table des Matières