Standby Time; Eco-Mode; Maintenance And Care - Rotel U27.25 Mode D'emploi

310324 rotel_U2725_U2730_inhalt_Rotel_Adagio277_Content

4.3 Standby time

This function allows you to program when the coffee machine should go to standby
mode after the last use. The following settings are possible:
1 h. = coffee strength button lights up
3 hrs. = coffee strength + 1-cup button light up
5 hrs. = coffee strength + 1-cup + 2-cups buttons light up
The factory setting is 1 h.
• Turn your machine ON using the on/off button (13).
• Press the 2-cups button (5) for about 4 seconds.
• The buttons for the current operating time setting light up.
• By pressing the 2-cup button (5), the machine changes to another operating time.
• For confirmation press the coffee strength button (3).
• To confirm your setting, the appropriate buttons light up twice in succession.
• Programming is completed and the system is in coffee-ready mode again.
4.4 ECO Mode
Your appliance is equipped with a modern, programmable power saving function
(ECO Mode). It means that the appliance turns to power-saving ECO Mode (with mini-
mal heat output = using less electricity) 3 minutes after it last has been used (factory-
set). When the appliance is started again from ECO Mode, the heating up can take a
few seconds longer.
The ECO Mode can be deactivated for the appliance to be on full stand-by while
switched on. The following settings are possible:
ECO-Mode activated
ECO-Mode deactivated = 1-cup button lights up
The factory setting is «ECO-Mode activated».
• Turn your machine ON using the on/off button (13).
• Press the coffee strength button (3) for about 4 seconds.
• The buttons for the current ECO-Mode setting light up.
• By pressing the steam button (6), the machine changes to the other setting.
• For confirmation press the coffee strength - button (3).
• To confirm your setting, the appropriate buttons light up twice in succession.
• Programming is completed and the system is in coffee-ready mode again.

5. Maintenance and care

5.1 Filter
Through a dealer you can obtain a special filter for the water tank as a special acces-
sory. If this filter is correctly used, the decalcifying intervals for your machine will be
lengthened.
☛
After fitting the filter, please set the water hardness to step 1 (see item 4.1). The
decalcifying indication will then only appear after a water consumption of
ca. 220 l.
= 1-cup + 2-cups buttons light up
13.05.11 09:18 Seite 29
29