Tractel POULISTOP 2 Notice D'utilisation page 15

 Weight : 4 kg
 Working load limit : 50 kg
Rope diameter 18 or 20 mm

 Maximum lifting height : 30 meters
 Complying with Machines Directive 2006/42/EC and EN13157
Group
Reference
code
D050B
192319
(hook)
D051B
192329
(collier)
Dimensions in mm
 Always use with only one operator.
Never exceed 50 kg compact and safe loads – including rope weight.

 Always check the rope type and wear before use (Ø 18/20 mm).
 Always check the safety latch before use (for DB50 models).
Always check that the anchorage point supports a minimum load of 108 kg.

 Always check all the braking components (wedge, rope, sheave) after any drop of the hoisted
load or sudden blocking of the rope.
 Any part with a defect must be replaced by a TRACTEL SOLUTIONS SAS genuine part.
Any deformed equipment must be immediately withdrawn from use

CAUTION
To guaranty its safety function, the POULISTOP2 wedge should always be kept free to move and clean.
Ice or mud could alter its functioning. It is not recommended to use the POULISTOP2 during freezing
temperatures.
The efficiency of the safety system depends on the friction between, the rope and the wedge. Those
components should then be systematically checked, and replaced when necessary. Always change the
wedge when using a new rope.
The operator should never leave the load without surveillance.
To avoid excessive wear of the wedge and non-monitored breaking distances, the operator should always
get close to the vertical position of the load before releasing the rope, avoiding this way violent blockings
between the rope, the wedge and the pin. When this occurs, it is therefore important to control that there
are no evident signs (at sight or touch) of damage of the outside fibres.
WLL : Working Load Limit
2
M 6116 M
rev 10 – 06.2021
GB
TECHNICAL DATAS
WLL per Rope Ø
2
fall (kg)
Min Max
50 18 20
SAFETY INSTRUCTIONS
Bottom of Sheave
groove Ø outside Ø
150 195
Weight
Bearings
(kg)
6000-
4
2RS
Page 15/42
www.tractel.com