Tractel POULISTOP 2 Notice D'utilisation page 13

Always concerned to improve the quality of its products, TRACTEL SOLUTIONS S.A.S reserves the right to
modify the specifications of the equipment described in this manual.
This manual outlines all necessary instructions for the safe and the correct operation of Charlet
POULISTOP2.
Before using and maintaining this Charlet POULISTOP2, for maximum safety and efficiency, make sure
these instructions are read, understood and applied by trained users.
This manual should be made available to every operator. Extra copies of this manual will be supplied on
Contact Tractel Solutions for any additional information.
 NEVER USE FOR PERSONNEL LIFTING
 Never use this safety pulley for a load exceeding its Working Load Limit (WLL). Shock loading or
specific conditions must also be taken into account when determining the appropriate product.
Charlet pulleys allow operations with a high safety level. Make sure that the people in charge

meet the safety requirements of these operations.
 Environmental conditions (rain, snow, mud,...) may alter POULISTOP2 technical characteristics,
so it is always necessary to perform tests before every use.
TRACTEL SOLUTIONS SAS disclaims all responsibility for the consequences due to disassembly

or modification of the product without prior agreement, especially in case of original components
replacement by spare parts of other origin.
 Modification or welding on this product is strictly forbidden without prior agreement from Tractel
Solutions.
For lifting applications, make sure the local applicable regulation is applied before using this

product.
 Only use good quality braided nylon rope that corresponds to the safety pulley characteristics. To
be avoided are the ropes characterized by the presence of nodules or coarsening, since the safety
system prevents their use.
 It is strictly forbidden to either stand or walk under the load.
Never move the hanging load above or near people.

 Attach the pulley to a fixed anchoring point and ensure that it can support at least 108 kg
 Warn the people around during the lifting or moving of the load. Make sure that the area below
the pulley is free of personnel, and specially that no one is circulating when using the POULISTOP2
Never use a damaged pulley or if you have a doubt over its correct functioning.

 Never use the pulleys in aggressive atmospheres.
 When the pulley is standing vertically on the floor, make sure it cannot tip. If the work area is not
stable, then lay the pulley on its lateral side plate.
 Always use the adapted individual protection equipment (gloves, safety boots, helmet, glasses...)
during the material handlings.
 Regularly examine the condition of the material (see below).
Only TRACTEL SOLUTIONS SAS genuine spare parts should be used.

M 6116 M
rev 10 – 06.2021
English
PRIORITY INSTRUCTIONS
request. Technical data sheet #6115 is also available.
GB
Page 13/42
www.tractel.com