English; Priority Instructions; Description And Applications Of The Equipment - Tractel Pal-beam Mode D'emploi

Always concerned to improve the quality of its products, TRACTEL SOLUTIONS S.A.S reserves the right to
modify without notice the specifications of the equipment described in this manual.
This manual outlines all necessary instructions for the safe and the correct operation of the TOPAL
clamps.
For safety's sake and efficiency of the equipment, you must become familiar with these instructions and
adhere to them before any use of the equipment.
The clamp can be used only by skilled and entitled personnel
 Never transport people using this equipment or its accessories.
Never exceed the working load limit WLL (see engraving).

 A minimum load of 5% of the WLL must be respected
 Never weld on the equipment or alter it.
Never use the equipment for any lifting other than the type it is designed for.

 Never go under the load.
 When laying down a load, the object must be stable before opening the clamp.
 Regularly check the correct condition of the equipment (see Storage & Maintenance paragraph).
Lifting and turning operations can only be done when the environment is free of obstacles

 Only TRACTEL SOLUTIONS spare parts must be used.

DESCRIPTION AND APPLICATIONS OF THE EQUIPMENT

Lifting beam PEF-PEM
Lifting component to handle an underhung load with several hooking points.
The beams and hooking points of the adjustable lifting beams have been designed for the lifting of
parts greatly out of balance (sketch 1).
The working parameters of a lifting beam are the working load limit (WLL) or (CMU), the maximum lifting
speed of the lifting appliance VL and the usage group depending on the frequency of the handling
operations and also whether or not the lifting beam is loaded to the maximum.
Pal-beam
Lifting component for symmetrical or unsymmetrical handling of loads.
The beam has two lower adjustable suspension sets on the flanges of the section with quick locking
thanks to a spindle.
These lifting points and the beam configuration enable the lifting of the load with a maximum inclination
angle of the section of 6° out of the horizontal line and a maximum inclination angle of 15° of the lower
suspension points (see scheme).
The technical sheets T 6041 (Pal-beam) and T 6042 (PEF-PEM) are at your disposal for technical
characteristics and more
M 6118 M
rev 8 – 06.2021
GB

English

PRIORITY INSTRUCTIONS

Page 11/32
www.tractel.com