Elem Garden Technic RIDER61-P Traduction Des Instructions Originales page 144

1. shift the accelerator lever to «OFF».
«OFF» position before leaving the machine unattended «OFF» position before leaving the machine unattended ! ! ! ! «OFF» position before leaving the machine unattended «OFF» position before leaving the machine unattended
5.4.10 cleaning the machine
Collector tray only for RIDER61-P model
After each mowing, clean the outside of the machine, empty the grass-catcher and shake
it to remove residual grass and earth.
containers full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using water and detergent,
taking care not to wet the engine, the electrical parts or the electronic card located under
the dashboard.
body and engine!
upper part of the cutting deck in order to keep maximum machine efficiency and
safety levels.
After each use, accurately clean the cutting deck to remove any grass remains or debris.
from the surrounding area when cleaning the cutting deck.
2. connect a water hose to its pipe fitting (1), and run water through it;
3. sit at the operator's position;
4. lower the cutting deck completely;
5. start the engine and stay in neutral;
6. engage the blade and leave it to turn for a few minutes.
Take off the grass-catcher, empty and rinse it, then put it in a position where
Page 144 de 181
Always make sure that the accelerator level is in the Always make sure that the accelerator level is in the Always make sure that the accelerator level is in the Always make sure that the accelerator level is in the
Always empty the grass-catcher and do not leave
Never use hose-nozzles or harsh detergents for cleaning the
Do not let debris and dry remains of grass accumulate in
Wear eye protection and keep people or animals away
a) When washing the inside of the cutting deck and
the collector channel, the machine must be on firm
ground:
1. fit the grass-catcher;
1