Elem Garden Technic RIDER61-P Traduction Des Instructions Originales page 141

5.4.2 Starting and moving without mowing
roads. It has to be used (as indicated by the Highway Code) in private areas closed
to traffic.
and the cutting deck put at its highest position
To start the forward movement:
1. put the accelerator control between the «SLOW» and «FAST» positions;
2.push the pedal right down (☛4.2) and put the gear change lever in 1st gear (☛4.4a).
3.release the pedal gradually to begin the movement.
Reach the desired operating speed using the accelerator and gear lever. To change gear,
the clutch must always be used by pushing the pedal (☛4.2).
engagement may cause tipping up and loss of control of the vehicle.
moving with the gear shift more than 1/3 of the way towards «F» to avoid suddenly moving with the gear shift more than 1/3 of the way towards «F» to avoid suddenly moving with the gear shift more than 1/3 of the way towards «F» to avoid suddenly moving with the gear shift more than 1/3 of the way towards «F» to avoid suddenly
engaging drive which could cause the vehicle to tip and loss of control. engaging drive which could cause the vehicle to tip and loss of control. engaging drive which could cause the vehicle to tip and loss of control. engaging drive which could cause the vehicle to tip and loss of control.
5.4.3 Braking
To brake:
1. first slow down the machine by reducing the engine speed;
2. push the pedal right down (☛4.2) to lower the speed even more until the
machine stops.
3. Move the speed gear shift (☛4.4) to idle «N» to permit gradual motion.
Page 141 de 181
this machine has not been approved for use on public
When moving the machine, the blade must be disengaged
.
The pedal must be released gradually as sudden
Do not suddenly release the pedal and do not start Do not suddenly release the pedal and do not start
Do not suddenly release the pedal and do not start Do not suddenly release the pedal and do not start