Stihl RE 361 Notice D'emploi page 42

English
Pressure/quantity control on the
machine
Working pressure and water flow rate
can be set on the high-pressure pump
for long-term adjustment in line with the
cleaning job concerned.
4
3
Turn the knob (3) to set the working
N
pressure and water flow rate
The pressure in the high-pressure pump
is indicated by a pressure gauge (4).
The indicated pressure is not always the
same as the pressure in the spray lance
before the nozzle. The pressure before
the nozzle depends on the position of
the pressure/quantity control lever on
the spray gun.
Pressure/quantity control on the spray
gun
The working pressure and water volume
can be set on the spray gun for short-
term adjustment in line with the cleaning
task.
40
Standard position
Move the setting lever to standard
position: Maximum working pressure
and water flow rate.
Reduced working pressure and water
flow rate
The setting lever can be used to adjust
the working pressure and water flow rate
in fine increments.
Pressure control at the nozzle
The operating pressure can be infinitely
adjusted at the nozzle.
RE 361, RE 361 PLUS, RE 461, RE 461 PLUS, RE 471 PLUS
Turn the nozzle sleeve – the
N
quantity of water delivered remains
unchanged
High-pressure hose
Do not buckle or loop the high-pressure
hose.
Do not place any heavy objects on the
high-pressure hose, and do not drive
any vehicles over it.
Storing accessories
Roll up the power cable and high-
pressure hose. Store the spray
attachment directly on the machine.