Stihl RE 361 Notice D'emploi page 35

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 59
Before starting work
Do not connect the high-
pressure cleaner directly
to the drinking water
main.
Only connect the high-pressure cleaner
to the drinking water main in conjunction
with a backflow preventer – see "Special
accessories".
Warning!
If drinking water has passed
through the backflow preventer, it
can no longer be regarded as
drinking water.
Do not use the machine with dirty water.
If there is a risk that dirty water will occur
(e. g., flowing sand), an appropriate
water filter must be used.
Inspecting the high-pressure cleaner
Warning!
The high-pressure cleaner should
only be used if it is in full working
order – risk of accident!
It must be possible to move the
switch to the 0 position easily
The switch must be in the 0 position
Inspect the high-pressure hose,
spray attachment and safety
mechanisms for damage
High-pressure hose and spray
attachment in good condition
(clean, moving easily) and correctly
assembled
RE 361, RE 361 PLUS, RE 461, RE 461 PLUS, RE 471 PLUS
For good control of the machine, the
handles should be clean and dry
with no oil or dirt on them
Check the oil level
Never attempt to modify the controls
or safety devices
Electrical connection
Warning!
Minimize the risk of electrical shock:
Voltage and frequency of the
machine (see rating plate) must
match the voltage and frequency of
the mains supply
Examine the power cord, power
plug and extension cord for
damage. Damaged cords,
couplings and plugs or power cords
that do not comply with the
regulations must not be used
Only connect the machine to a
correctly installed power socket
The insulation on the power cord
and any extension cord, the plug
and the coupling must be fully intact
Never touch the power plug, power
cord and extension cord and
electrical plug connections with wet
hands
Warning!
Route the power cord and extension
cord properly:
Observe the minimum cross-section
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
that it cannot become damaged and
no one is endangered – danger of
stumbling!
Use of unsuitable extension cords
can be dangerous. Use only
extension cords that are approved
for outdoor use and are
correspondingly marked and have a
sufficient cross-section
The connector and coupling of the
extension cord must be waterproof
and not lie in water
It is advisable to keep the plug
connection at least 60 mm above
the ground/floor. for example, by
using a cable reel
don't let the cord rub against edges
or pointed or sharp objects
don't squeeze the cord under doors
or windows
if cords become snarled – unplug
the power plug and unsnarl the cord
always unroll the power cord from
the cable reel completely to avoid
risk of fire due to overheating
English
33

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Re 461Re 471

Table des Matières