Standy, Run And Autorun - Simco-Ion Charge Master Tiny Notice D'utilisation

If an "Undefined param" appears in the info screens of the CM Tiny on the
Manager, the Manager must be supplied with the newest software.
Download the latest software version on
and follow the "Upgrade" instructions as described in the manual of the Manager.
The parameters "Device name" and "Machine position/name" can be changed at you discretion.
This can be useful to keep an overview when several CM Tinys are connected to one machine.
Figure 8, change CM IQ Tiny parameters
To activate the high voltage output of the CM IQ Tiny, the following conditions must be met:
• The generator must be set to "Run" (6.3.1 Standby, Run and Autorun)
• A "Setpoint" has to be set (6.3.2 Control mode)
• The "Remote" signal must be active or the generator must be set to continuous mode
(6.3.3 Continuous and Remote mode)
The current output voltage and current can be read out with the parameters "Output voltage"
and "Output current" (Figure 9).

6.3.1 Standy, Run and Autorun

Press on the main screen of the Manager IQ Easy on the CM IQ Tiny icon. Press
to set the generator to Run. On the main screen
displayed in Figure 7. Press
(Figure 10) is set to "Yes", the generator will switch to Run after start up.
Figure 10
CMTinyCMTinyIQ_UM_9752097710_NL_D_GB_F_V1_1
www.simco-ion.co.uk/software
Figure 9
to set the generator to Standby. When the parameter "Autorun"
Figure 11
, the generator will now appear as
(Figure 8)
56