Installation; Checks; Fitting The Cm Tiny (Iq) - Simco-Ion Charge Master Tiny Notice D'utilisation

5-pin M12 connector
Earth connection
Earth connection
Figure 2, dimensions of the CM Tiny (IQ)

5 Installation

Warning:
- The electrical installation must be carried out by an electrical engineer with the
relevant training and qualifications.
- Disconnect the power supply before carrying out work on the unit.
- The CM Tiny (IQ) must be properly earthed. Earthing is needed to ensure proper
operation of the equipment and to avoid electrical shocks upon contact.

5.1 Checks

- Check that the equipment is undamaged and that you have received the correct version.
- Check that the data on the packing slip corresponds to the data shown on the product
received.
- Check that you have received a connection cable with a 5-pin M12 connector (female).
A standard connection cable can be obtained from Simco-Ion Netherlands or from the agent
in your region.
See the spare parts list.
If the connection cable is to be fitted through a cable carrier, please use the special flexible
connection cable available from Simco-Ion or another type that is suitable for this purpose.
If you have any problems or are unsure, please contact Simco-Ion Netherlands or the agent in
your region.

5.2 Fitting the CM Tiny (IQ)

Using the connecting cables of the charging bar/charging electrode, the CM Tiny (IQ) should be
mounted as close to the electrode head as possible, preferably so that the electrode head can
be removed without dismantling the entire generator.
- Fasten the generator to a stable machine part using the four ø6 mm assembly holes in the
assembly plate.
CMTinyCMTinyIQ_UM_9752097710_NL_D_GB_F_V1_1
Electrode head
52