Preparation For Work - Installation; Application - Solo 69 00 150 Instructions D'emploi

Preparation for work – Installation; Application
6. Preparation for work –
Installation
Switch off engine and remove spark plug cap
before installing (or dismantling) the cultivator
attachment.
The cultivator attachment with factory fitted
lower shaft tube is designed solely for
installation on the SOLO brushcutter 129LTS and
129BTS, both with sectional shaft.
A simple, quick tool change is made possible as
the lower shaft tube can now be replaced with
the tool head attached.
Fig. 2
To separate the shaft sections:
Release the straining screw (1).
Pull out the fixing pin (2).
Pull the lower shaft tube (3) with gearbox
from the female coupling.
When assembling ensure that the hollow shaft
in the lower shaft tube mates with the quadrant
in the upper part of the drive shaft. When
assembling it may be necessary to lightly jiggle
the lower shaft tube. The fixing pin (2) must
audibly lock into position in the shaft tube
holes.
Ten tighten the straining screw (1).
ENGLISH 6

7. Application

Note the safety instructions when starting the
engine and when working with the completely
assembled tool.
Put on the shoulder strap and hang the
completely assembled tool, with engine idling,
onto the strap.
Only accelerate when working.
Fig. 3
It is possible to work the cultivator in a forward
and backward motion or even to side to side.
Regularly clean the tool (tilling blades and
protective shield) by clearing clogged earth,
grass, weeds or similar materials during
operation. When doing so, always first switch
off the engine and remove the spark plug cap.
Never operate in the slipping range of the
clutch.