Fix The Sword - GRAUPNER Racing 65 Mode D'emploi

Fix the sword

Plug the sword (1) from below into the sword bag (please pay attention to the direction) and scre-
wed up with the knurled nut (2).
Because of the weight the boat is now stable in the boat stand for the next steps.
Then bring the sail to closing position with your
transmitter (lever arm shows the nose cone). Mark
the position (after the roller block), now open sail
servo and knotting a snap at the marked point.
There, the jib and mainsheet have to be hung later.
innovation & technologie
Now thread the cord through the hole (left of the
number 25 in the drawing) between the openings
for rowing and sailing servo into the boat after they
have formed a loop at one end. This loop will be
fixed by a screw behind the hole on the cover.
From there, the cord must be threaded through
the pulley block to the power sail, then through the
tube to the right and at the rear by the roller block
(34).
29