Bühler technologies Baseline Notice De Montage page 5

Baseline
105
Intake filter 3 µm
Fig. 1: Baseline installation
Then install the probe to the mating flange or the sampling
point using the appropriate seal.
Condensate trap (optional)
When using a condensate trap, connect it to the probe hose.
Please note the correct condensate trap position: The arrow
must point in the direction of gas flow, away from the probe.
This ensures the moist gas can first condense before reaching
the filter element. The most upright condensate trap position
possible allows maximum condensate absorption without it
flowing into the chamber with the filter element.
4.3 Removal
WARNING
Gas leakage, condensate, hot surfaces
Burns and / or health hazards due to gas / condensate!
a) The sample gas and/or condensate may be hazardous to
the health.
b) Parts near the sampling point may be hot.
c) The probe may become very hot due to the process
gasses.
ð Close the gas supply, if necessary flush the probe with air,
and allow the probe to cool down before beginning in-
stallation or maintenance.
ð Wear safety gloves and goggles.
• Empty the condensate trap as described in chapter Main-
tenance .
• Remove the probe from the sampling point. Rinse the
probe with dry, clean air.
• Remove the mounting elements from the sampling tube.
• Inspect the filter and seals, and replace damaged or worn
parts.
• Pack the probe in the transport packaging.
5 Operation and controls
NOTICE
The device must not be operated beyond its specifications.
Before starting the device, verify
• the hose connections are not damaged and correctly in-
stalled.
• no parts of the sample gas probe have been removed.
• ambient parameters are met.
BX464001 ◦ 09/2016
Fitting cone Ø10-20
Fitting cone Ø20-60
Assembly plug R2
300
Hose DN6 3m
Mounting flange DN65 PN6
Mounting flange ANSI DN3"-150
Condensate trap
• the technical specifications were followed!
Regularly check and empty the condensate trap throughout
operation as described in chapter Assembly and disassembly .
Ensure the condensate does not enter the filter chamber. The
filter will otherwise be unusable.
6 Maintenance
Always observe the applicable safety- and operating regula-
tions when performing any type of maintenance. Please refer
to the original operator's manual on the included CD or online
at www.buehler-technologies.com for maintenance informa-
Ø6
tion.
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
Bühler Technologies GmbH 5