Technical Data - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

11

Technical data

Optical data (typ.)
Scanning distance (from reference point)
Scanning distance tolerance
Size of light spot
Scanning range with reflective foil RF10 C
Type of light
Max. ambient light
Colour / intensity tolerance
Electrical data (typ.)
Operating voltage U
B
Residual ripple within U
B
Power consumption I no load
O
Switching output Q
Output current I
e
Voltage drop U
d
Switching frequency (ti/tp 1:1)
Max. capacitive load
Time level for Q
KL / TR input
When trigger input is set
- Blanked out (triggered) mode
- Unsolicited mode
- Min. response time
When key lock is set
- Keys are locked
- Keys are free
IN ET input (Extern teach mode)
Teach in > 3 s (time lock)
Normal mode
Min. response time
IN ES input (Extern scan mode)
Scan > 3 s (time lock)
Operating mode
Min. response time
Serial interface
Protective circuits
VDE protection class
60
FT 50 C-1-S1-L8 FT 50 C-2-S1-L8
12 ... 32 mm 15 ... 30 mm
± 6 mm (with Tol C ± 5 mm (with Tol C 3
3 and Tol I 2) and Tol I 2)
Ø 4 mm with scan- 2x2 mm
ning distance 22 mm ning distance 22 mm
application-specific
white light (pulsed)
EN 60947-5-2
adjustable (4 levels each)
12 ... 28 V DC
10 %
≤ 40 mA
PNP or NPN, N.O./ N.C. reversible
≤ 100 mA
≤ 2.4 V
max. 500 Hz
< 100 nF
50 ms drop-out delay time adjustable
Input key lock or triggering (adjustable)
PNP / NPN
when > 12 V ... 28 V
when < 3 V or open
10 ms
PNP / NPN
when > 12 V ... 28 V
when < 3 V or open
PNP / NPN
> 12 V ... 28 V
< 3 V or open
2 ms
PNP / NPN
> 12 V ... 28 V
when < 3 V or open
2 ms
RS485 (half-duplex), 1 stop bit, no parity, baud rate selectable via
telegram and Progsensor software (factory setting 19200 Baud)
Reverse battery protection, short circuit protection (not RS485)
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Mounting and
operating instructions
FT 50 C-3-S1-L8
18 ... 22 mm
± 2 mm (with Tol C 3
and Tol I 2)
with scan- 5x1 mm with scan-
2 2
ning distance 22 mm