Guide To Symbols; Safety Instructions - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Mounting and
operating instructions
1

Guide to symbols

Warnings and other information are signalled by symbols in this manual. They are accompanied by hea-
dings. The following symbols are used:
WARNING
... indicates a possibly dangerous situation which can cause death or serious injury if not avoided.
CAUTION
... indicates a possibly dangerous situation which can cause material damage if not avoided.
INFORMATION
Useful tips and recommendations as well as information for efficient use of the sensor.
2

Safety instructions

In order to avoid accidents, injuries or material damage, act with caution and always observe the following
safety instructions:
WARNING
The product is not approved for the protection of personnel (no safety component according to
Machinery Directive).
All the safety and handling instructions indicated in these mounting and operating instructions
must be observed.
The valid on-site accident prevention regulations and general safety regulations must be obser-
ved.
Read these mounting and operating instructions carefully before using the sensor.
The manual is a product component and must be kept in immediate proximity of the sensor and
accessible to personnel at all times.
Connection, mounting and configuration of the sensor is to be carried out by trained personnel
only.
It is forbidden to tamper with or alter the device in any way!
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04 35