Menu „S": Scanning A Single Colour Range - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Step Menu item Activity
7 Confirm with
8 Press
several
times until
the required
tolerance is
selected
9 Confirm with
* when switching mode = N.O. = Factory setting is selected.
Repeat the configuration procedure (steps 1 – 8) to teach (add) further colours.
7.3.5 Menu „S": Scanning a single colour range
INFORMATION
• Function for the scanning of an inhomogeneous colour surface.
• If a colour is scanned, all previously taught and scanned colours / colour ranges are deleted.
• After the scanning process, the yellow LED „C" lights up when the switching output „Q" is
active a colour has been detected (when switching mode = N.O. = Factory setting is selected).
Procedure:
Step Menu item Activity
1 Operating Position object
mode (no
menu item)
2 Press
SET
> 3 s
until LED „C"
(yellow) flashes
3 Press
4 Scan colour Press
range
and keep
pressed
44
Picture follows Remark
C S +/F
SET
C S
+/F
SET
Picture follows Remark
C S +/F
C S +/F
2x
C S +/F
SET
Colour tolerance is stored.
Sensor is ready for the setting of intensity tolerance
LED „C" (yellow) lights up when colour is detected,*
LEDs „Tol.I" (red) light up.
Select intensity tolerance (grey selectivity).
1 2
C S +/F C S +/F
1 = smallest tolerance, 4 = greatest tolerance
2 = factory setting
Sensor is ready for use
LED „C" (yellow) lights up when colour is detected / swit-
ching output „Q" is active*.
Observe operating parameters such as scanning distance,
direction of movement, inclination etc. (see chapter 5
„Mounting").
LED „C" (yellow) flashes, when time lock is open and
configuration mode is activated.
Menu „Scan colour range" is selected LED „S" (yellow)
flashes.
The colour range is scanned as long as
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Mounting and
operating instructions
3 4
C S +/F C S +/F
SET
is pressed.