Starting; Operation - EUROM Force 3000 IND Manual D'instructions

Mounting is done as follows:
- Attach the bracket using the 3 screws included in the delivery.
- Place the connecting piece on top of the cleaner head. The cleaner head has 2
holes; the threaded piece goes into the larger hole.
- Invert the cleaner head and push the spinner at the inside tightly onto the
connecting piece: the small tube into the appropriate hole in the threaded piece.
- The connecting piece fits onto the spray lance. The spray lance fits onto the
spray gun (included in the delivery) using an adapter.

Starting

 Place the high-pressure cleaner on a solid, even and horizontal surface.
 Insert the plug into the socket.
 Do not mount the spray lance!
 Before use, de-aerate the machine as follows:
- Turn the switch to ON.
- Unlock the trigger of the spray gun.
- Squeeze the trigger of the spray gun to start the machine.
- Let the machine run (max. 2 minutes) until the water comes out of the
spray gun without bubbles.
- Let go of the trigger of the spray gun.
- Lock the trigger of the spray gun.

Operation

Attention: Letting the high-pressure cleaner run dry for more than 2 minutes
damages the high-pressure pump. If the machine does not build up
pressure within 2 minutes, switch off the machine and follow
instructions in the Problems & Solutions chapter.
Attention: When using the jet, maintain a distance of at least 30cm for cleaning
painted surfaces in order to prevent damage.
Attention: Make sure that the ON/OFF switch is on OFF and insert the plug into a
correctly installed socket.
Attention: The high-pressure cleaner must be used on a safe and stable surface in
a standing upright position (see illustration).
 Connect the machine to the electricity and water supply as described.
 Open the water supply.
 Hold the spray gun with both hands.
45