Table Des Matières - Efco GSH 51 Manuel D'utilisation Et D'entretien

TRANSLATION OF ORIGINAL INSTRUCTIONS
INTRODUCTION
For correct use of the machine and to avoid
accidents, do not start working until you have
read this manual carefully. You will find
explanations concerning the operation of the
various parts plus instructions for necessary
checks and relative maintenance.
NOTE: The descriptions and illustrations
contained in this manual are not binding. The
manufacturer reserves the right to undertake
any modifications it deems necessary without
revising this manual.
In addition to the operating instructions, this
manual contains paragraphs that require your
special attention. Such paragraphs are marked
with the symbols described below:
WARNING: where there is a risk of an accident or
personal, even fatal, injury or serious damage to
property.
CAUTION: where there is a risk of damaging the
machine or its individual components.
WARNING
RISK OF HEARING DAMAGE
IN NORMAL CONDITIONS OF USE, THIS MACHINE
MAY EXPOSE THE OPERATOR TO A PERSONAL DAILY
NOISE LEVEL EQUAL TO OR HIGHER THAN
85 dB (A)
CONTENTS
1. EXPLANATION OF SYMBOLS AND
SAFETY WARNINGS _______________
2. CHAIN SAW COMPONENTS _________
3. SAFETY PRECAUTION _____________ 10
4. FITTING THE BAR AND CHAIN _______ 11
5. STARTING _______________________ 11
6. STOPPING THE ENGINE ____________ 14
7. USE ____________________________ 14
8. MAINTENANCE ___________________ 16
9. STORAGE ________________________ 19
10. TECHNICAL DATA _________________ 20
11. DECLARATION OF CONFORMITY ____ 22
12. WARRANTY CERTIFICATE __________ 23
13. TROUBLE SHOOTING CHART _______ 24
1. EXPLANATION OF SYMBOLS AND
SAFETY WARNINGS (Fig.1)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
3. Type of machine: CHAIN SAW.
4. Serial number
5. Year of manufacture
6. Primer bulb
7. Chain brake, activated (right). Chain brake,
not activated (left).
2. CHAIN SAW COMPONENTS (Fig. 2)
1. Choke lever
2. Throttle trigger
3. Throttle trigger lockout
4. Carburetor adjustment screws
5. Inertial brake lever
6. Exhaust muffler
7. Chain
8. Guide bar
9
9. Air filter cover
9
10. On/off switch
11. Fuel tank cap
12. Starter handle
13. Oil tank cap
14. Primer bulb
15. Lateral chain tensioner screw
16. Front handle
17. Rear handle
18. Bar cover
GB
F
D
E
NL
P
GR
TR
CZ
SK
RUS
UK
PL
H
LV
EST
LT
RO
9