IKRA GBHI 750 Traduction Du Mode D'emploi D'origine page 32

Air filter
Fuel filter
Spark plug
The engine turns,
Carburetor
but stalls or does
not accelerate
Cooling system
correctly
Spark suppressor
The engine does N/A
not engage
STORING
Transporting the machine in a car, please empty the fuel
tank completely first to avoid the leakage.
Empty the fuel
1. Place the machine on even and stable surface.
Warm up the engine for several minutes and then
stop it.
2. Loosen the fuel tank cover and remove it.
3. Drain fuel into a container thoroughly.
4. Press the intake pump several times until fuel be-
gins to empty the bulb.
5. Drain fuel again.
6. Reinstall the fuel tank cover.
Store the machine, operating instructions and where nec-
essary the accessories in the original packaging. In this
way you will always have all the information and parts
ready to hand.
Pack the device well or use the original packaging in or-
der to avoid transit damage.
Store the machine in dry and well ventilated surroundings
and with the fuel tank empty. Do not store fuel next to the
machine.
DISPOSAL
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into nation-
al right, power tools that are no longer usable
must be collected separately and disposed of in
an environmentally correct manner.
Never dispose the residual fluids into household waste
too. It must be collected separately and disposed of in an
environmentally correct manner too.
GB | Operating Instructions
Dirty air filter
Dirty fuel filter
Dirty or worn spark
plug
Bad adjustment
Excessive
Plate cracked, conta-
minated or perforated
N/A
ORDERING SPARE PARTS
If you need accessories or spare parts, please contact our
Service department.
When working with this tool, do not use any accessory parts
other than those recommended by our company. Otherwise
the operator or others in the vicinity could suffer serious
injuries, or the tool could be damaged.
REPAIR SERVICE
Repairs to tools may only be performed by a specialist.
Please describe the fault that you have encountered
when sending the machine in for repair.
WARRANTY
For this petrol tool, the company provides the end user
- independently from the retailer's obligations resulting
from the purchasing contract - with the following war-
ranties:
The warranty period is 36 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of not fitting
accessories, repair with parts that are no original parts of
the manufacturer, use of force, strokes and breaking as
well as mischievous overloading of the motor are exclud-
ed from this warranty. Warranty replacement does only
include defective parts, not complete devices. Warranty
repair shall exclusively be carried out by authorized ser-
vice partners or by the company's customer service. In
the case of any intervention of not authorized personnel,
the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
GB-14
Fair wear and tear Clean or replace
Dirt or residue in Replace
the fuel
Fair wear and tear Clean, adjust or
replace
Vibration Adjust
Prolonged use Clean
in dirty or dusty
places
Fair wear and tear Replace
Internal engine Ask your distributor for
problem advice