Spare Parts Gb; Waste Disposal And Environmental Protection Gb - IKRA GBS 3,6 LI Manuel D'utilisation

The two (red) marks on the blade must be in line. (Fig. 10)
Do not hold the blade on the cutting edges
when changing! If the on/off switch is activated
unintentionally, severe injuries can occur.
Place the blade in the gearbox housing. Ensure that the
blade is in the position shown. (Fig. 11)
Note: Ensure that the blade rests on the two plastic hold-
ers (3) and ensure that the blade is properly seated on
the four fixation elements (4). (Fig. 12)
Insert the gearbox cover into the guides (1) and slide it
forward until the closure tab engages (2) (Fig. 12).
The device is now ready for operation again.
Maintenance
(Fig. 9 + 10)
Clean the blade from any crushed plants and dirt. The
blades should be detached at least once a season for
the removal of debris. Lubricate the A pinion and the B
back of the blade with a light oil. Do not lubricate the mo-
tor and other parts. Should the blade become dull after a
long period of use, a spare part can be ordered.
Warning! The leading edges of the blades must be oiled
to ensure proper lubrication. If the leading edges are not
oiled, blade durability may be adversely affected.
If the cutting tools have become dull after long use
please replace them with original spare parts.
Clean the device using only a brush or cloth. Do never
wash down the device with water and do never dip the
device into water.
Apply protective spray to the blades after each use.
Replace blunt blades.
Always put on the blade guard after use.
Examine the tool for obvious defects and have it repaired
in an authorised service shop if required.
Storage
Always store the tool in a dry, clean place outside the
reach of children. Make sure that the place of storage
is frost-free.
Spare parts
If you need accessories or spare parts, please contact our
Service department.
When working with this tool, do not use any accessory
parts other than those recommended by our company.
Otherwise the operator or others in the vicinity could suffer
serious injuries, or the tool could be damaged.
Grass cutting blade.........................................
Shrub cutting blade ........................................
Charging device for accumulator....................
GB | Operating Instruction
Waste disposal and environmental protection
Before removing the installed accumulator with printed
board from your appliance, actuate the ON/OFF switch
and wait until the accumulator has fully discharged.
Then use a screwdriver to undo all screws on the appli-
ance and open the casing.
Remove the printed board with lithium ion cell and
disconnect the connections on the accumulator/printed
board.
Then hand in the printed board with lithium ion cell at an
accumulator/battery recycling point for proper disposal.
In line with the European Electrical and Electronic Equip-
ment Directive, after removing the printed board with
accumulator, you must deliver the appliance for environ-
mentally friendly recycling.
We would, however, also be happy to handle the proper
disposal of the appliance with accumulator on your
behalf. To take advantage of this offer, send the appli-
ance to the service address provided in the operating
instructions.
50800025
50800027
50800015
GB-8
Do not discard electric tools in the household
waste!
In accordance with European Directive 2012/19/
EC on waste electrical and electronic equipment
and its implementation in national law, waste
electric tools must be collected separately for
environmentally-compatible re-use.
Defective or spent batteries must be recycled
properly in accordance with the latest regula-
tions concerning battery and accumulator dis-
posal. As a consumer you are legally obliged to
return used batteries and accumulators.