IKRA GBHI 750 Traduction Du Mode D'emploi D'origine page 31

Problem Check
Fuel at the carbu-
retor
Fuel at the cylinder
The engine stalls,
is difficult to start
or does not start
Sparks at the spark
plug electrodes
Sparks at the
spark plug
GB | Operating Instructions
Cleaning and lubrication
Clean any resin and plant residue from the blades using
cleaning agent before and after using the machine.
Lubricate the blade bars with antirust grease before long
periods of storage.
Repairs
Only an authorized service centre should repair the ma-
chine.
Condition
The fuel does not arri-
ve at the carburetor
The fuel does not
arrive at the
cylinder
There is fuel in the
exhaust
There is no spark
There is no spark
GB-13
Cause Solution
Fuel filter blocked Clean or replace
Fuel supply Clean or replace
blocked
Carburetor Ask your distributor for
advice
Carburetor Ask your distributor for
advice
The fuel mixture is Open the throttle valve
too rich Clean or replace the
air filter
Adjust the carburetor
Ask your distributor for
advice
Switch in off Set the switch to the
position ON
position (Run)
Electrical problem Ask your distributor for
advice
Locked switch
Bad spacing of the Adjust the gap to 0,6-
electrodes 0,7 mm
Electrodes conta- Clean or replace
minated
Electrodes conta- Clean or replace
minated with fuel
Defective spark Replace the spark plug
plug