Location; Measurements - Tritec TRI-KA Mode D'emploi

176_Warnings Warnings_177

1.5 location

Do not use the characteristics analyser for measurements near
combustible gases and dust or other flammable materials. Risk of
explosion!
Do not use the device in rain or under wet or very humid condi-
tions due to the risk of electric shocks. Prevent liquid from pene-
trating into the device, as this may cause irreparable damage. The
permissible ambient temperature range for the TRI-KA is be-
tween 0 and 50 °C. Do not expose the TRI-KA to long periods of
direct sunlight.

1.6 Measurements

Measurements on photovoltaic systems should only be carried out
by properly trained electricians! Carefully read the user manual
before using the instrument. Keep the manual with the measur-
ing instrument. The devices should only be opened and repaired
by the manufacturer.
Before taking a measurement, disconnect all loads (e.g. inverters,
etc.) from the photovoltaic system.
For measurements of strings switched in parallel and modules
switched in series, the maximum measuring range of the device
must be observed.
When using the device on a roof make sure to comply with all
safety regulations relating to roof work as well as with the re-
quirements for working on electrical equipment!