Scan monitors for signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel
and stops only if a matching signal is present.
To start/stop scanning, press the key programmed as [Scan].
•
The
indicator appears during Scan.
•
When a signal is detected, Scan pauses at that channel. The
transceiver will remain on the busy channel until the signal is no
longer present, at which time Scan resumes.
Note: To use Scan, there must be at least 2 channels added to the
scanning sequence.
PRIORITY SCAN
If a Priority channel has been programmed, the transceiver
will automatically change to the Priority channel when a call is
received on that channel, even if a call is being received on a
normal channel.
•
The
indicator appears when the selected channel is the Priority
channel (depending on dealer setting).
TEMPORARY CHANNEL LOCKOUT
During scan, you can temporarily remove specifi c channels
from the scanning sequence by momentarily pressing the key
programmed as [Scan Delete/Add] while Scan is paused at
the undesired channel. To temporarily remove a zone, press
and hold the [Scan Delete/Add] key while Scan is paused at a
channel in the undesired zone.
•
The channel/zone is no longer scanned. However, when scanning
is ended and restarted, the Scan settings return to normal.
SCAN
13