Conventional Scan; Add To Scan / Delete From Scan - Kenwood TK-2180 Mode D'emploi

If the Scan function is programmed, Conventional zones or
channels can be scanned by pressing the key programmed as
Scan. Scan can be used as either Single Scan or Multi Scan.
• Single Scan monitors only the channels of the currently selected
zone, which have been added to the scanning sequence. If set
up to scan Priority channels, the Priority channels will be scanned
even if they are not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been
added to the scanning sequence.
To activate Scan, press the key programmed as Scan.
• The icon and "
appear on the display.
• The zone add indicator (
when the selected zone is added to the scan sequence. The
channel add indicator (
when the selected channel is added to the scan sequence.
• When a call is received, scanning stops and the zone and channel
digits appear. Press the PTT switch and speak into the microphone
to respond to the call. The transceiver will continue scanning after
a predetermined time delay if the PTT switch is released and no
further signal is received.
To stop scanning, press the Scan key again.
A S / D
DD TO CAN
Press the key programmed as Scan Delete/Add to add or
remove each channel to or from the scan sequence.
• The channel add indicator (
display when the selected channel is added to the scan sequence.
Press the key programmed as Zone Delete/Add to add or
remove each zone to or from the scan sequence.
• The zone add indicator (
when the selected zone is added to the scan sequence.

CONVENTIONAL SCAN

" or the revert zone and channel number
S
ELETE FROM CAN
) will appear on the display
) will appear on the display
) will appear on the
) will appear on the display
19