Selecting And Editing The Effects - Korg SV-1 Stage Vintage Piano Mode D'emploi

22 – Using the SV-1 | Selecting and editing the effects
S
ELECTING AND EDITING THE EFFECTS
You can select the various effects and amp models by turning the corresponding TYPE
knobs. You can change the effect main setting by using the DEPTH, INTENSITY,
SPEED, DRIVE knobs. Deeper editing can be done through the SV-1 Editor software.
Effects and the amp simulation can also be turned on or off by pressing the corre-
sponding ON/OFF button. Changes can be saved, together with a sound, into one of
the eight FAVORITES locations.
We will experiment with the effects, by going from the beginning of the effect chain,
where the most mind-boggling preamp effects are located, to the end, with the cream-
iest, most reassuring touch-up effects are contained. Just consider this effect chain as
the effect chain of a classic instrument amplifier.
NOTE: With some of the effects, the name of the actual parameter you will be editing may differ
from what is printed on the piano panel. The name that appears in the SV-1 Editor is the real
name, as reported in the following tables. E.g., with the Pre FX Compressor, the SPEED and INTEN-
SITY knobs control the Sensitivity and Level parameters respectively.
To turn each section on, press the corresponding ON/OFF button to turn its LED
1.
on. To turn the section off again, press the ON/OFF button again to turn the LED
off.
Stereo Limiter
Stereo Mastering Limiter