Korg SV-1 Stage Vintage Piano Mode D'emploi page 37

Use the three EQUALIZER knobs to adjust the low, mid and high frequencies.
2.
After having changed a knob position, you can return to the default settings by
pressing the corresponding knob.
WARNING: Extreme EQ settings may produce a very loud signal.
The SV-1 includes a stompbox simulator, that recreates the sound of a pedal effect
3.
inserted before the amplifier's input. Use the TYPE knob of the PRE FX section to
select a different stompbox effect (compressor, booster, U-Vibe, vibrato, tremolo or
wah).
If the wah effect is selected, use the AUTO/PEDAL button to change between
Auto-Wah (LED off, filter changing automatically depending on the sound and the
playing dynamics) and Pedal-Wah (LED on, filter controlled by an expression
pedal connected to PEDAL input 2; if no pedal is connected, the filter will be
fixed).
NOTE: Before using an expression pedal to control the wah, it is advisable to calibrate it. See
"Calibrating the pedals" on page 30.
You can change the speed of the modulation of the U-Vibe or tremolo effects by
using the SPEED knob, and the intensity of the modulation by using the INTEN-
SITY knob. To return to the default settings, press the SPEED or INTENSITY
knob.
NOTE: The booster stompbox may produce a very loud signal.
PRE-FX type
Comp
Boost
U-Vibe
Vibrato
Tremolo
Vox Wah
NOTE: The Manual Wah control only works when the AUTO/PEDAL button is in Pedal mode.
The SV-1 includes an amp simulator, to choose among a series of vintage and mod-
4.
ern instrument amplifiers. Use the TYPE knob of the AMP MODEL section to
select a different amplifier. You can change the preamp's volume (therefore, its
overdrive saturation) by using the DRIVE knob. To return to the default setting,
press the DRIVE knob.
Using the SV-1 | Selecting and editing the effects – 23
SPEED knob
Sens
Drive
Speed
Type
Speed
Manual Wah
INTENSITY knob
Level
Level
Depth
Mix
Depth
Type (V-847, V-848)