Hold Display; Holding The Digital Value On The Screen - Chauvin Arnoux C.A 25 Mode D'emploi

If during the recording the SMOOTH symbol is displayed, the recording applies to
the filtered measurement values (see ch. "SMOOTH MEASUREMENT").
Switching off the MIN/MAX record function
The MIN/MAX function is switched off either by pressing the
more than 2 seconds, or by turning the rotary switch.
Note: The MIN/MAX function isn't available when counting. Pressing
when COUNT is displayed sets off a 4 kHz sound signal, and it isn't taken into
account.

HOLD DISPLAY

This function is accessible with the
(PRGM symbol not displayed).
Pressing
HOLD
analogue display continues to indicate the instantaneous measurement value.
The display indicates HOLD. Pressing the HOLD button again resets the instru-
ment to instantaneous measurement and
on MIN/MAX record mode
HOLD
When
HOLD
- HOLD and PAUSE are displayed
- The recording is stopped and the values contained in the MIN and MAX
memories are the last values recorded before
- The digital display indicates the value of the last measurement, or the MIN
or MAX value if the instrument was on read mode.
- The analogue display continues to indicate the current measurement.
Pressing
MIN MAX
- the HOLD and PAUSE symbols disappear from the display
- the digital display indicates the current measurement or the contents of the
MIN/MAX memory on read mode.
maintains the display of the last measurement whilst the
is pressed when RECORD is displayed:
again unblocks the recording of MIN and MAX values:
button only during measurement
HOLD
disappears from the display.
HOLD
61
button for
MIN MAX
MIN MAX
.
HOLD