Chauvin Arnoux C.A 25 Mode D'emploi page 80

- Measurement read instruction
Codes to send to the instrument to start the measurement emission:
- 3 F Hexa, 63 decimal, corresponding graphic: ?
The response to this instruction is the emission by the instrument, on the
TxD output, of the codes corresponding to the results of the measurements
present at the moment when the instruction is sent.
The presentation of the results is the same as for the local instruction:
from one to four lines from 22 to 27 characters according to the functions
of the instrument.
If during the measurement printout the rotary switch is turned or if a button
is pressed the printout of the current message terminates with a carriage
return and a line advance, then the instrument is switched to the new
function requested.
The remote measurement instruction does not start the SCANNING function
even if it is programmed.
- Complete readout of the memory
Codes to send to the instrument to read the contents of the memory :
- 2A Hexa, 42 decimal, corresponding graphic: *
The response to this read instruction is the emission by the instrument, on the
TxD output, of the codes corresponding to the different values contained in
the memory.
This output supplies all the values contained in the programmed memory.
The non-programmed functions are indicated by six hyphens (------).
The presentation of the results is done in superimposed lines, each line
corresponds to a programmed function.
Each line contains three groups of data separated by 3 spaces and ends by
a carriage return and a line advance :
<group 1> <group 2> <group 3>
77