Chauvin Arnoux C.A 25 Mode D'emploi page 74

B/ Positioning the decimal point
In addition to the 5 digits, the display has a decimal point which can take the five
following positions :
When using this function and when there is no programmed value, the decimal
point furthest to the left is lit.
To move the displayed decimal point to the right, press
digit on the right flashes. Press
Any other press on
positioned at the required place.
Example: 1. Display
2. Button
3. Display
4. Button
5. Display
When the active digit is located at the far left or right of the display, any new press
on
to the displays simple press
exited to the left or the right.
Because of the possibility of five positions for the decimal point, the programming
definition cannot be higher than the measurement definition.
In this case the comparison to set the alarms will always be done with the real
measurement definition.
On programming mode, if you press one of the four arrows without first having
indicated the value to be programmed, the CA 27 emits a 4 kHz beep and the press
is not taken into account.
.-.-.-.-.-.
or
.
.
.
or will display "- - -". To get the decimal point to return
again to activate the decimal point.
allows the decimal point to be
or depending on whether it
71
until the last