Chauvin Arnoux C.A 25 Mode D'emploi page 81

Group 1 contains 4 characters, aligned on the right, indicating the programmed
functions. They are given in the order :
- LO AL : for the low threshold
- HI AL : for the high threshold
- K : for the multiplying coefficient
- SCAN : for the number of seconds of the scan
The characters that are not used are replaced by spaces.
Group 2 contains 6 characters, aligned on the right, indicating the digital value
programmed in 5 digits with a decimal point if necessary. The non-significant digits
are replaced by spaces.
Group 3, which only exists in the case of thresholds, contains 1 to 6 characters,
aligned on the left, indicating the different programming units. They are output in
this order :
- tr/min
- m/min
- %
- ms
- Hz
- ft/min
- RPM
- m
- ft
- tr
- Rev
- imp. (for pulses in the case of counting without units).
The memory readout prints 48 lines each comprising 3 groups of data.
The last line always ends with a carriage return and a line advance.
The COM and PRINT symbols always remain lit whilst the data is output.
During the printout of the values contained in the memory, turning the rotary
switch or pressing one of the buttons has no effect on the data output.
78