Electrical Data; Fluid Installation - Burkert 6126 Manuel D'utilisation

7.5. label
Example:
Body material
Seal material
Orifice
Circuit function
Type
6606 T 1,6 FKM PD
G1/8
24V
00450000
Identification number
Voltage/frequency output
Nominal connection pressure
english
16
8. insTallaTiOn
8.1. safety instructions
Danger!
Risk of injury from high pressure in the equipment!
• Before loosening the lines and valves, turn off the
pressure and vent the lines.
Risk of injury due to electrical shock!
• Before reaching into the device or the equipment,
switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety
regulations for electrical equipment!
Warning!
Risk of injury from improper installation!
• Installation may be carried out by authorized technicians
only and with the appropriate tools!
Risk of injury from unintentional activation of the
system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following installation, ensure a controlled restart.
english
18
PNVAK 2 bar
DC 3.4W
CE
W14UN
7.6.

electrical data

Connections: Spade connection in accordance
with DIN 43650 C for cable plug
Type 2506 on top or on side
Rectangular plug for Type 2505
2 FEP flying leads, AWG24,
500 mm long
Power supply: 12 V DC
24 V DC
110 – 120 V UC
230 – 240 V UC
Voltage tolerance ±10 % - Residual ripple 10 %
Nominal output
12 – 24 V 3.4 W
110 – 240 V 4.0 W
Nominal
operating mode 100 % continuous operation
for block installation if temperatures of media or
surrounding area above +40 °C:
Intermittent duty 40 % (10 min)
Note the information specified on the label for
voltage, type of current, and pressure.

8.2. fluid installation

Danger!
Risk of injury from high pressure in the equipment!
• Before loosening the lines and valves, turn off the
pressure and vent the lines.
Installation position: any, actuator preferably upwards.
Installation
→
Before installation, clean any possible dirt off the pipe-
lines and flange connections.
→
If required, install a dirt trap to prevent malfunctions.
Pay attention to the flow direction of the valve.
Type 6126 / 6606
english
17 17
Mesh size:
5 µm
english
19 19