7.6.
electrical data
Connections:
DIN EN 175301-803 Form C
for cable plug Type 2506
DIN 43650 Form B
for cable plug Type 2507
Wire connection on request
Power supply:
24 V DC ± 10 % -
max. residual ripple 10%
24 V / 50 Hz
110 / 230 / 50 Hz
± 10%
Voltage tolerance:
Nominal output:
4 W
Nominal operating mode: 100% continuous operation
for block installation
2 W continuous operation on
request
4 W intermittent operation 60%
(30 min)
Note the information specified on the label for
voltage, type of current, and pressure.
english
16
8.2.
fluid installation
Danger!
Risk of injury from high pressure in the equipment!
•
Before loosening the lines and valves, turn off the pres-
sure and vent the lines.
Installation position:
any, actuator preferably upwards.
Procedure:
→
Before installation, clean any possible dirt off the pipe-
lines and flange connections.
→
If required, install a dirt trap to prevent malfunctions.
Pay attention to the flow direction of the valve.
from 1(P) → 2(A) (CF C) or
from 1(P) → 2(B) (CF D)
english
18
Mesh size:
0.2 – 0.4 mm
8.
insTallaTiOn
8.1.
safety instructions
Danger!
Risk of injury from high pressure in the equipment!
•
Before loosening the lines and valves, turn off the
pressure and vent the lines.
Risk of injury due to electrical shock!
•
Before reaching into the system, switch off the power
supply and secure to prevent reactivation!
•
Observe applicable accident prevention and safety
regulations for electrical equipment!
Warning!
Risk of injury from improper installation!
•
Installation may be carried out by authorized techni-
cians only and with the appropriate tools!
Risk of injury from unintentional activation of the
system and an uncontrolled restart!
•
Secure system from unintentional activation.
•
Following installation, ensure a controlled restart.
Body with threaded connection:
→
Use PTFE tape as sealing material
note!
Caution risk of breakage!
•
Do not use the coil as a lifting arm.
→
Hold the device with a suitable tool (Open-end wrench)
on the body and screw into the pipeline.
Valve with flanged connection:
Cover plate
Type 6012
english
17
17
Nut
Coil
Seal
english
19
19